Smooth Stopping Power: Comprehensive Guide to Mercedes Car Brake Services

Imagine you a driving on a road with a very high speed, then you would only feel safe if your brakes are working properly. Because with such a high speed, the momentum of the car also becomes high, to bring its speed to zero, you have to apply brakes to slow it down at a certain rate so that the car can be brought to stop safely in a minimum possible stopping distance. Immediate stopping can lead to deadly hazards. So, for safety, the brake services are done. In this article, I’m gonna provide you a guide for Mercedes car brake services.

Why car brake services are so important?

The vitality of the service depends on how important is the systems that are covered in the service. The brakes are no doubt one of the top vital components in a vehicle. So, it is important to service the brakes whose parts are more likely to wear depending on the number of uses and its age.

The brakes are used when you want to stop to have your work or to avoid any hits or collision with other vehicles or any wall, fences, pedestrians while driving or while getting into the parking place. Brakes not only keeps the car safe from any type of dangers, but stops the car to complete the journey. A vehicle is incomplete without brakes because without it, the car cannot reach to the destination.

The brakes are the mechanical system which are subjected to stress and strain, so it is obvious that such parts can wear with time. It also depends on the driver that in which way he is using the brakes. The careless use of the brakes can wear off the parts quicker. The wearing of the brake parts can ultimately lead to the brake failure. If the brakes start to fail, then you cannot make the car slow or stop during the emergency, which can lead to the brake failure. If the brake is failed while you are on the roads, then that ride can be a great risk for your life. To make the drive safer, the brake service is must.

Guide for Mercedes car brake service

For the service of the brakes, you have to know the parts of the brakes which can develop faults and need inspection. These are - brake booster, brake pedals, the master cylinder, brake fluid lines, hoses. In case of disc brakes, there are brake pads, brake rotors and brake calipers. In the drum brakes, there are brake shoes, brake drum and the wheel cylinder.

Check the following signs in your car

 Soft brake pedal

 Hard to press the pedal

 Rattling and grinding noise

 Pulling to left or right

 Vibration when brakes are applied

 Brake warning light

If any of the signs is found, then know that you have to get the brakes inspected. When there is some strange noise like grinding or rattling, then check the brake pads and the piston in the wheel cylinder or brake calipers.

If the brake pedal is too soft to press, then check the brake fluid leaks near your wheels. You can also inspect the fluid reservoir, fluid lines and the hoses to locate the leaks. If the fluid level is low you have to add new fluid.

If the brake pedals feel too hard or stiff to press, then there must be some contamination in the brake fluid or the brake booster is damaged. You have to check the fluid and change it or check the brake booster and replace it.

If you find that your car is pulling to one side, then you must check the piston in the brake caliper or wheel cylinder in drum brakes. It is not obvious that there is fault in the brakes. If the brake piston is good, then check the tire pressure and the wheel alignment too.

The warped rotors and the ABS issues cause the vibrations. Get them checked well.

It is recommended that the brakes should be inspected once in every 6000 miles. The brake service must be done on the regular basis so that the brakes life would remain long.

Conclusion

The cost of the brake repair can vary with the cause. General replacements can cost between $150 - $300. but if there is problem in the ABS, brake booster or the rotors, then the cost can be more. Increase the longevity of the brakes by servicing it regularly.